Kit Installation Notes

Installation Kit

Recommended Tools and Supplies (Not Included)

See F2 FasCard Mounting Guide for more information.


Step 1 - Install Mounting Bracket

  1. Remove the existing Coin Drop.
    1. Refer to manufacturer documentation as needed.
  2. Insert the C-6920R1 Mounting Bracket into the Coin Vault and secure using the C-1059 Kep Nuts.
  3. Secure the C-5414 F2 Mounting Bracket to the C-6920R1 Mounting Bracket using the C-5702 Chase Nipple and C-5703 Nut.

Step 2 - Connect Machine Start Harness

  1. Disconnect the Coin Drop from the Machine Control Assembly.
  2. Connect C-5380 Combination Harness to the machine where the Coin Drop was previously connected.
    1. The 6 pin 2x3 female connector will not be connected to anything as the Coin Drop will not be used.

Step 3 - Connect Power

  1. Tap power as described in the Fascard Reader Install - Universal Concepts document using the C-5101 Spade Taps provided.
  2. Connect the C-5210 Power Adapter Harness to the installed spade taps. Connect the opposite end to the C-5602 Power Converter.
  3. Connect the C-5500 Power Extension Harness to the appropriate connector on the C-5602 Power Converter. The remaining cable end connects to the FasCard reader.

Step 5 - Final Connections

  1. Feed remaining harness ends through mounting bracket.
  2. Connect the free end of the C-5380 Machine Start Harness to port 2 (Pulse Connection Port) as shown in the image above.
  3. Connect the free end of the C-5500 Power Extension Harness to port 1 (C-5500 Power Harness Connection Port) as shown in the image above.
  4. The small, black 5 pin connector will not be connected as the Coin Drop is not being used.
  5. Connect FasCard reader to base as described in the F2 FasCard Mounting Guide.
  6. Program the card reader address as described here: How to Program Address on a FasCard Reader.