The Talos Bill Note Acceptor (BNA)
The Talos Bill Note Acceptor (BNA) By Crane Payment Innovations (CPI) is the latest in a line of Bill Note Acceptor models to be used with CCI's X-Changer Cabinets and FasCard Kiosks. This detailed page discusses its properties, configuration, and installation of the device.
| Part ID | Description |
|---|---|
| C-1004-V2 | |
| C-5660-V2 |
Operation Details
As with the MEI Legacy 2000 BNAs, the Talos BNA connects using the same two ports on the side of the bill acceptor.
With native functionality for both v2 LaundryCard X-Changers and Touch Kiosks,
Key Differences
- C-5660-V2 models are fit for Touch Kiosk use.
- C-1004-V2 models are fit for v2 LaundryCard X-Changers and Add Value Kiosks.
- Add Value Kiosks utilize a different Communication Harness (C-5690R2) and is thus incompatible with the legacy C-5690 harness.
- Where the MEI Legacy 2000 series of BNAs had a set of eight (8) dipswitches for manual configuration, the Talos BNA utilizes a dollar-sized configuration sheet insert.
- The 'Accepted Orientations' setting does not work with a Talos BNA, requiring a filled out configuration sheet to set bill orientation preferences.
Although the Talos BNA works natively out-of-the-box, a coupon booklet may be needed (T2700 Models(link)-- T6 / T8 Models(link)) in the event that any configuration is lost over time.
High Acceptance
All Talos BNAs out-of-the-box are pre-programmed under Mode 0 (High Acceptance) by default. Any modes above Mode 0 introduce stricter security features (i.e. High Security) and should only be used when necessary.
- As opposed to its predecessor, the Talos BNA only utilizes the front LED lights, both for recognition in use and in troubleshooting.
- To trigger front bezel LED error flash codes, partially insert and hold a bill in the bill path until the bezel lights flash.
Refer to the below chart to determine the issue.
# Of Flashes
Status
Recommended Solution None No Power Restore power to BNA or machine. 1 or 4
Bill Path Blocked
Check for jams. Remove bill magazine and review bill path, cross channel, lower housing assembly, and inspect the unit. 2
Disabled From System (idle)
Ensure the unit has been enabled, checking both hardware/connectivity and software, if necessary.
3
Lower Housing Assembly Issue
Check that lower housing assembly is seated. ensure bill path is clean. 5
Magazine/Stacker Removed
Reattach magazine. Continuous Fast
Magazine/Stacker Full
Empty magazine and reattach. Continuous Slow
Unit Failure
Replace unit.
Installation
WARNING
Disconnect any electrical device from power before performing any work on the device. It is recommended that the instructions contained herein be performed by individuals who are qualified to perform these tasks. Card Concepts Inc. takes no responsibility for the accuracy of this document or any damage that may occur to target equipment. Technical Support recommends using all appropriate safety equipment (such as hand and eye protection) during execution of the instructions below.
Installing the Talos BNA aligns directly with its predecessor in clearance and mounting placement, with minor exceptions in connectivity.
Related Documents
Talos Coupon Booklet (For Manual Configuration)