Page History

Required Hardware

Install Kit (K-5704-CO)

Recommended Tools and Supplies (Not Included)

See FasCard Mounting Guide for more information.

Installation

1. Place the C-5700-TEMP Drill Template on the desired mounting location.
2. Verify included harnesses will reach desired location without encountering interference from internal machine components.
3. Refer to FasCard Mounting Guide for further instructions.

1. Tap power as described in the Fascard Reader Install - Universal Concepts document using the C-0122 Spade Taps provided.
2. Connect the C-5210 Power Adapter Harness to the installed spade taps. Connect the opposite end to the C-5602 Power Converter.
3. Connect the C-5500 Power Extension Harness to the appropriate connector on the C-5602 Power Converter. The remaining cable end connects to the FasCard reader.

1. Remove the existing Alliance Jumper Plug at H8 and connect the C-0110-CP Jumper Plug to the Machine Control Assembly.
2. Connect the C-0110-TOP Machine Start Harness to the Machine Control Assembly at H5.
   1. The opposite end of this harness connects directly to the FasCard reader.

1. Gather the remaining ends of the C-5500 Power Extension Harness and C-0110-TOP Machine Start Harness.
2. Feed harness ends through mounting hole as described in the FasCard Mounting Guide.
3. Connect the C-0110-TOP Machine Start Harness to port 1 (Serial Communication Port) as shown in Fig. 1a, above.
4. Connect the C-5500 Power Extension Harness to port 4 (C-5500 Power Harness Connection Port) as shown in Fig. 1a, above.
5. Connect FasCard reader to base as described in the FasCard Mounting Guide.
6. Program the card reader address as described here: How to Program Address on a FasCard Reader.

Associated Equipment Models

Additional Information

• FasCard Admin Site - Equipment Setup
• FasCard Admin Site - Machine Setup
• FasCard Admin Site - Pricing & Features Schedule