Page tree

Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Required Hardware

Multiexcerpt include
MultiExcerptNameAssumptions
nopaneltrue
PageWithExcerptLCE:Master Excerpt List

Bw part list
PartsC-5001

 

Recommended Tools and Supplies (Not Included)

See FasCard Mounting Guide for more information.

Install Guide

UI Text Box
sizemedium
typewarning

Confirm machine power is disconnected before beginning installation!

UI Text Box
sizemedium
typewarning

Use caution and appropriate protection to prevent hand and eye injury during installation!

|

Panel
Panel
bgColorgrey

Step 1 - Install Mounting Bracket 

Bw part list
PartsC-5700-TEMP,C-5800
SingleRowtrue

  1. Place the C-5700-TEMP Drill Template on the desired mounting location.
  2. Verify included harnesses will reach desired location without encountering interference from internal machine components.
  3. Refer to FasCard Mounting Guide for further instructions.
Panel
bgColorgrey

Step 2 - Connect Power

Bw part list
PartsC-0122,C-5210,C-5602,C-5500
SingleRowtrue

  1. Tap power as described in the Fascard Reader Install - Universal Concepts document using the C-0122 Spade Taps provided.
  2. Connect the C-5210 Power Adapter Harness to the installed spade taps. Connect the opposite end to the C-5602 Power Converter.
  3. Connect the C-5500 Power Extension Harness to the appropriate connector on the C-5602 Power Converter. The remaining cable end connects to the FasCard reader.
Panel
bgColorgrey

Step 3 - Connect Machine Start Harness

Bw part list
PartsC-0110-CP,C-0110-TOP
SingleRowtrue

  1. Remove the existing Alliance Jumper Plug at H8 and connect the C-0110-CP Jumper Plug to the Machine Control Assembly.
  2. Connect the C-0110-TOP Machine Start Harness to the Machine Control Assembly at H5.
    1. The opposite end of this harness connects directly to the FasCard reader.
Panel
bgColorgrey

Step 4 - Connect and Mount FasCard Reader

Fig. 1b - FasCard Reader Connection Ports

  1. Gather the remaining ends of the C-5500 Power Extension Harness and C-0110-TOP Machine Start Harness.
  2. Feed harness ends through mounting hole as described in the FasCard Mounting Guide.
  3. Connect the C-0110-TOP Machine Start Harness to port 1 (Serial Communication Port) as shown in Fig. 1b, above.
  4. Connect the C-5500 Power Extension Harness to port 4 (C-5500 Power Harness Connection Port) as shown in Fig. 1b, above.
  5. Connect FasCard reader to base as described in the FasCard Mounting Guide.
  6. Program the card reader address as described here: How to Program Address on a FasCard Reader.

Anchor
models
models

Associated Equipment Models

...