Page History

1. Place the C-5700-TEMP TEMP Drill Template on  on the desired mounting location.
   1. Front Mount over card reader slot recommended.
   2. Alternative top mount can be used, recommend obtaining C-5633-R1 Label to cover card slot.
2. Verify included harnesses will reach desired location without encountering interference from internal machine components.
3. Refer to FasCard to F1 Reader Mounting Guide for  for further instructions.

1. Tap power as described in the the Fascard Reader Install - Universal Concepts document  document using the C-0122 5101 Spade Taps provided provided.
2. Connect the C-5210 5210 Power Adapter Harness to  to the installed spade taps. Connect the opposite end to the C-5602 5602 Power Converter.
3. Connect the C-5500 5500 Power Extension Harness to  to the appropriate connector on the C-5602 5602 Power Converter. The remaining cable end connects to the FasCard reader.

1. Remove the existing Alliance Alliance Jumper Plug at  at H8 and connect the C-0110-CP Jumper Plug to the CP Jumper Plug to the Machine Control Assembly.
2. Connect the C-0110-TOP TOP Machine Start Harness to the  to the Machine Control Assembly Assembly at H5.
   1. The opposite end of this harness connects directly to the FasCard reader.

Image Removed

1. Feed harness ends through mounting hole as described in the the FasCard Mounting Guide.
2. Connect the C-0110-TOP TOP Machine Start Harness to  to port 1 (Serial Communication Port) as shown in Fig. 1b, above.
3. Connect the C-5500 5500 Power Extension Harness to  to port 4 (C-5500 Power Harness Connection Port) as shown in Fig. 1b, above.
4. Connect FasCard reader to base as described in the FasCard the F1 Reader Mounting Guide.
5. Program the card reader address as described here: How to Program Address on a FasCard Reader.