Versions Compared


  • This line was added.
  • This line was removed.
  • Formatting was changed.
Cci readerinstall main

Install Mounting Hardware

Cci readerinstall kit
KitDescSurface Mount - Door StrikerStrike
  1. Place the C-6700-TEMP Drill Template on the desired mounting location.
  2. Mark hole "C" for the pilot hole to run the harnesses to the reader. Mark "D" and "E" holes to provide mounting points for the reader bracket.
  3. Use a 1-1/8" hole saw to drill a hole at position "C".
  4. Place and align C-5414F2 Mounting Bracket so that the center hole aligns with hole "C" and the two holes immediately to the left and right align with the holes marked for "D" and "E"
  5. Using material appropriate fasteners (Not Provided.), secure the C-5414 F2 Mounting Bracket to the surface using points "D" and "E"

Connect Power

Cci readerinstall kit
KitDesc120v Wall Power
  1. Connect the C-5200-72 Powerline Adapter Harness to an 120v electrical outlet.

  2. Connect the white, 3-pin connector from the C-5200-72 Powerline Adapter Harness to the matching end on the C-5602R1 Power Converter.
  3. Connect the 4-pin connector from the C-5500 Power Extension Harness to the matching end on the C-5602R1 Power Converter.

Connect Machine Interface Harness

Cci readerinstall kit
KitDescPulse - Circuit Interruption
  1. Connect the one of the ends of the C-5256 Machine Start Harness to the positive terminal from the door strike power source. Connect the other spade connector to the positive terminal on the door strike.
    1. Note: Depending on the door strike installed, spade terminals may not be available or may be too far apart for the harness to reach. In this case, cut the ends of the C-5256 Machine Start Harness and then cut and splice into the positive lead wire (In any pairing.). 
  2. The negative lead from the door strike power source should remain connected to the negative terminal on the door strike.
  3. Note: If the door strike requires a normally closed circuit instead of a normally open one, move the wire in the 6th position to the 4th position on the C-5256 Machine Start Harness. Diagram
diagramNameFasCard Door Strike Wiring

Connect and Mount Reader

Multiexcerpt include
MultiExcerptNameF2 Reader
PageWithExcerptCCIDOC:_Reader Ports

  1. Feed remaining harness ends through the mounting hole.
  2. Connect the free end of theC-5256 Machine Start Harness to port 2 (Pulse Connection Port) as shown in the image above.
  3. Connect the free end of the C-5500 Power Extension Harness to port 1 (Power Harness Connection Port) as shown in the image above.