Page History

1. Place the C-6700-TEMP Drill Template on the desired mounting location.
2. Verify included harnesses will reach desired location without encountering interference from internal machine components.
3. Refer to FasCard Mounting Guide for further instructions.

1. Tap power as described in the Fascard Reader Install - Universal Concepts document by connecting the C-5203 Power Adapter Harness to terminal strip or contacts L1 and L2.
   1. Connect the ground wire to a chassis screw.
   2. Connect the opposite end to the C-5602 Power Converter.
2. Connect the C-5500 Power Extension Harness to the appropriate connector on the C-5602 Power Converter. The remaining cable end connects to the FasCard reader.

1. Disconnect the Coin Drop from the Machine Control Assembly.
2. Connect the C-6255 Coin Sense Harness to the harness connected to the Coin Drop.

1. Connect the C-5264 Machine Start Harness to the Coin Counting Board Harness where the coin drop was previously connected.
2. The remaining tap connections should be inserted between the coin block solenoid and the existing harness connected to the solenoid.
   1. Disconnect the existing harness and match the male/female connectors on that side and the solenoid side of the circuit. 

1. Feed remaining harness ends through mounting hole as described in FasCard F1 Reader Mounting Guide.
2. Connect the free end of the C-5264 Machine Start Harness to port 2 (Pulse Connection Port) as shown in the image above.
3. Connect the free end of the C-6255 Coin Sense Harness to port 3 (Coin Sense Harness Connection Port) as shown in the image above.
4. Connect the free end of the C-5500 Power Extension Harness to port 4 (C-5500 Power Harness Connection Port) as shown in the image above.
5. Connect FasCard reader to base as described in the FasCard Mounting Guide.
6. Program the card reader address as described here: How to Program Address on a FasCard Reader.

Associated Equipment Models