Page History

1. Place the C-6700-TEMP Drill Template on the desired mounting location.
2. Verify included harnesses will reach desired location without encountering interference from internal machine components.
3. Refer to F2 FasCard Reader Mounting Guide for further instructions.

1. Tap power as described in the Fascard Reader Install - Universal Concepts document by connecting the C-5336 5213 Power Adapter Harness to the Terminal Block.
   1. Connect Green wire to ground.
2. Connect the C-5336 5213 Power Adapter Harness to the C-5602 Power Converter.
3. Connect the C-5500 Power Extension Harness to the appropriate connector on the C-5602 Power Converter. The remaining cable end connects to the FasCard reader.

1. Disconnect the Coin Drop from the Machine Control Assembly.
2. Connect the C-6253 Coin Sense Harness to the harness connected to the Coin Drop.

1. Connect the C-5254 Machine Start Harness to the Machine Control Assembly where the coin drop was previously connected.

1. Feed remaining harness ends through mounting hole as described in F2 FasCard Reader Mounting Guide.
2. Connect the free end of the C-5254 Machine Start Harness to port 2 (Pulse Connection Port) as shown in the image below.
3. Connect the free end of the C-6253 Coin Sense Harness to port 3 (Coin 1 Connection Port) as shown in the image below.
4. Connect the free end of the C-5500 Power Extension Harness to port 1 (Power Connection Port) as shown in the image below.
5. Connect FasCard reader to base as described in the F2 FasCard Reader Mounting Guide.
6. Program the card reader address as described here: How to Program Address on a FasCard Reader.

Associated Equipment Models