Panel |
---|
Step 1 - Install Mounting Bracket |
Bw part list |
---|
Parts | C-5700-TEMP,C-5800 |
---|
SizingMode | Height |
---|
ShowDesc2 | false |
---|
ShowDesc3 | false |
---|
SingleRow | true |
---|
|
- Place the C-5700-TEMP Drill Template on the desired mounting location.
- Front Mount over card reader slot recommended.
- Alternative top mount can be used, recommend obtaining C-5633-R1 Label to cover card slot.
- Verify included harnesses will reach desired location without encountering interference from internal machine components.
- Refer to FasCard Mounting Guide for further instructions.
Panel |
---|
Step 2 - Connect Power |
Bw part list |
---|
Parts | C-0122,C-5210,C-5602,C-5500 |
---|
SizingMode | Height |
---|
ShowDesc2 | false |
---|
ShowDesc3 | false |
---|
SingleRow | true |
---|
|
- Tap power as described in the Fascard Reader Install - Universal Concepts document using the C-0122 Spade Taps provided.
- Connect the C-5210 Power Adapter Harness to the installed spade taps. Connect the opposite end to the C-5602 Power Converter.
- Connect the C-5500 Power Extension Harness to the appropriate connector on the C-5602 Power Converter. The remaining cable end connects to the FasCard reader.
Panel |
---|
Step 3 - Connect Machine Start Harness |
Bw part list |
---|
Parts | C-0110-CP,C-0110-TOP |
---|
SizingMode | Height |
---|
ShowDesc2 | false |
---|
ShowDesc3 | false |
---|
SingleRow | true |
---|
|
- Remove the existing Alliance Jumper Plug at H8 and connect the C-0110-CP Jumper Plug to the Machine Control Assembly.
- Connect the C-0110-TOP Machine Start Harness to the Machine Control Assembly at H5.
- The opposite end of this harness connects directly to the FasCard reader.
Panel |
---|
Step 4 - Connect and Mount FasCard Reader |
Bw part list |
---|
Parts | C-5500,C-0110-TOP |
---|
SizingMode | Height |
---|
ShowDesc2 | false |
---|
ShowDesc3 | false |
---|
SingleRow | true |
---|
|
Multiexcerpt include |
---|
MultiExcerptName | Reader ports |
---|
PageWithExcerpt | CCIDOC:_FC Reader Installation |
---|
|
- Feed harness ends through mounting hole as described in the FasCard Mounting Guide.
- Connect the C-0110-TOP Machine Start Harness to port 1 (Serial Communication Port) as shown above.
- Connect the C-5500 Power Extension Harness to port 4 (C-5500 Power Harness Connection Port) as shown above.
- Connect FasCard reader to base as described in the FasCard Mounting Guide.
- Program the card reader address as described here: How to Program Address on a FasCard Reader.
|