Skip to end of metadata
Go to start of metadata
Table of Contents
Purpose

Use this guide when configuring Maytag machines in Fascard

Assumptions

This document assumes the installer is familiar with programming Maytag washers.  This procedure is required to allow the CCI card reader to start the washer in Gen1 mode.

Configuration

Maytag MFR/MFS/MXR/MXS Washers

NOTE: Cycle Pricing and Deluxe/Ultimate pricing are not supported.

Single Price

SettingValue
Value of Coin 10.25
Regular Cycle Price2.00
Price DisplayHidden
Coin/DebitCoin.Card
Clear EscrowYes
Special Pricing...Off
Enhanced Pricing...None

Super Cycle

Use above settings plus the following:

SettingValue
Enhanced PricingUpgrade
Super Cycle DisplayYes
Super Cycle Price0.25
Deluxe Cycle DisplayNo
Ultimate Cycle DisplayNo

Maytag MHN/MAH/MAT Washers

Single Price

CodeCode DescriptionValue
6Regular Cycle Price08 (8 coins)
bValue of Coin 105 (5 nickels - $0.25)
FEnhanced Pricing Option00 (Off)
JCoin Option_d (Coins disabled)
LPrice Suppression OptionPS (On)
nClear Escrow OptionCE (On)

Super Cycle

Use above settings plus the following:

CodeCode DescriptionValue
FEnhanced Pricing OptionSu (Super Cycle enabled)
HSuper Cycle Upgrade Price01 (1 coin)

Maytag MVW Top-Load Washers

NOTE: Only supports single price for all cycles. Modifier pricing is not supported.

CodeCode DescriptionValue
6 NORMALNormal Vend Price08 (8 coins)
6 DELICATESDelicate Vend Price08 (8 coins)
6 POWERWASHPowerwash Vend Price08 (8 coins)
2Special Pricing Option00 (Off)
bValue of Coin 105 (5 nickels - $0.25)
JCoin/Debit Option_d (Debit)
LPrice Suppression OptionPS (On)
nClear Escrow OptionCE (On)