Overview
Equipment Details | Average Installation Time | On This Page | ||
Make: Wascomat
| TODO |
Associated Models
D735F
D735S
D735S NR
D735SNR
D767
D767NR
D783
D783 NR
D783NR
This document assumes the installer has working knowledge of hand tools and of the target machine in question. Physical modification of machine may be required, including modification of machine panels and internal modification to accommodate cables or harnesses. It is recommended that the instructions contained herein be performed by individuals who are qualified to perform these tasks. Card Concepts Inc. takes no responsibility for the accuracy of this document or for any damage that may occur to target machine.
Required Hardware
Card Reader
| Part ID | Description | Image |
|---|---|---|
| C-0103-B | LaundryCard Reader V3 - RevB |
Recommended Tools and Supplies (Not Included)
Installation
- Page not found for multiexcerpt macro.
Install Mounting Hardware
Remove existing coin box and coin drop.
Install the C-0934 Mounting Bracket over the coin vault and coin drop opening. Secure to the machine using the C-1059 kep nuts.
Connect Machine Interface Harness
Pulse
- Connect the C-0126R1 Machine Start Harness to the coin 1 connector on the Machine Control Assembly.
Connect and Mount Reader
TODO - Include picture of LaundryCard reader connection
- Feed remaining harness ends through the mounting hole as described in the LaundryCard Kit Installation Guidelines.
- Connect the free end of the C-0126R1 Machine Start Harness to port 2 (Pulse Connection Port) as shown in the image above.
- Secure the LaundryCard reader to the machine as described in the LaundryCard Kit Installation Guidelines.
Machine Configuration
TODOLaundryCard Configuration
Use the following settings depending on the Machine Start Harness used.
Pulse (C-0126R1)
- Equipment Type: SingleVend
- Pulse Length: 63
- Page not found for multiexcerpt macro.