LaundryCard Documentation
Space shortcuts
Page tree
Skip to end of metadata
Go to start of metadata

Overview

Equipment Details


Average Installation Time


On This Page

Make: Dexter


TODO


Associated Models

DRC552
DRC55CGQSS
DRC55Q
DRC55QSS
DRC55QSSEC
DRC55QSSEC
DRC55QSSEC
DRC55QSSEC
DRC55QSSEC
DRC55QSSEC
DRC55QSSEC
DRC55QSSEC
DRC55QWHT

This document assumes the installer has working knowledge of hand tools and of the target machine in question. Physical modification of machine may be required, including modification of machine panels and internal modification to accommodate cables or harnesses. It is recommended that the instructions contained herein be performed by individuals who are qualified to perform these tasks. Card Concepts Inc. takes no responsibility for the accuracy of this document or for any damage that may occur to target machine.

Required Hardware

Card Reader

Part IDDescriptionImage
C-0103-B
LaundryCard Reader V3 - RevB

Recommended Tools and Supplies (Not Included)

Installation

    Page not found for multiexcerpt macro.
The page: null was not found. Please check/update the page name used in the 'multiexcerpt-include' macro.

Install Mounting Hardware

P/N: C-0015
Label
Reader Cover Label
Qty: 1
P/N: C-0031
Label
Dexter Instruction Panel
Qty: 1
P/N: C-0134
Standoff
8-32" x 1" - Hex
Qty: 2
P/N: C-0905
Drop Cover
2-3/8" x 4-5/8"
Qty: 1
P/N: C-0906
Spacer Plate
5 1/2" x 4 3/8"
Qty: 1
P/N: C-0936
Vault Mount Bracket
Qty: 1
P/N: C-1043
Screw
8-32 x 1-3/4" - Flat
Qty: 2

  1. Remove existing coin box and coin drop.

  2. Bend the side tabs of the C-0936 Bracket outward and install into the coin vault. The tabs should snap into place securing the bracket.

  3. Attach the C-0134 Standoffs to the Bracket.

  4. Install C-0905 Drop Cover where the coin drop was previously installed. Secure in place using existing hardware.
    1. Apply C-0031 Label on to Drop Cover.
  5. Place C-0906 Spacer Plate over coin vault opening between the reader and machine.

Connect Machine Interface Harness

Pulse

P/N: C-5256
Machine Start Harns (pulse)
20" - Male taps, Rq. Female
Qty: 1

  1. Connect the C-5256 Machine Start Harness to the harness previously connected to the micro switch.

Connect and Mount Reader

TODO - Include picture of LaundryCard reader connection

  1. Feed remaining harness ends through the mounting hole as described in the LaundryCard Kit Installation Guidelines.
  2. Connect the free end of the C-5256 Machine Start Harness to the appropriate port.
    1. For pulse start harnesses (white connector), connect to port 2 (Pulse Connection Port) as shown in the image above.
    2. For serial start harnesses (black connector), connect to port 1 (Serial Connection Port) as shown in the image above.
  3. Secure the LaundryCard reader to the machine as described in the LaundryCard Kit Installation Guidelines.

Machine Configuration

TODO

LaundryCard Configuration

Use the following settings depending on the Machine Start Harness used.

Pulse (C-5256)

  1. Equipment Type: SingleVend
  2. Pulse Length: 55

    Page not found for multiexcerpt macro.
The page: null was not found. Please check/update the page name used in the 'multiexcerpt-include' macro.