This document is intended to guide the user through installation utilizing the kit numbered according to the document title. A list of associated equipment models including control information and additional installation notes can be found below.
Kit Installation Notes
This document assumes the installer has working knowledge of hand tools and of the target machine in question. Physical modification of machine may be required, including modification of machine panels and internal modification to accommodate cables or harnesses. It is recommended that the instructions contained herein be performed by individuals who are qualified to perform these tasks. Card Concepts Inc. takes no responsibility for the accuracy of this document or for any damage that may occur to target machine.
Required Hardware
Card Reader
Part ID | Description | Image |
---|---|---|
C-5001 | F1 FasCard Reader |
Installation Kit
Recommended Tools and Supplies (Not Included)
See F1 Reader Mounting Guide for more information.
Installation
Confirm machine power is disconnected before beginning installation! Use caution and appropriate protection to prevent hand and eye injury during installation!
Step 1 - Install Mounting Bracket
C-0141 | C-0934 | C-1059 |
---|---|---|
Screw | Mounting Bracket | Nut |
- Install the C-0934 Mounting Bracket into the Coin Vault. Use C-1059 to secure to Coin Vault.
Step 2 - Connect Power
C-5101 | C-5210 | C-5500 | C-5602 |
---|---|---|---|
Spade Taps | Power Adapter Harness | Power Extension Harness | Power Converter |
- Tap power as described in the Fascard Reader Install - Universal Concepts document using the C-5101 Spade Taps provided.
- Connect the C-5210 Power Adapter Harness to the installed spade taps. Connect the opposite end to the C-5602 Power Converter.
- Connect the C-5500 Power Extension Harness to the appropriate connector on the C-5602 Power Converter. The remaining cable end connects to the FasCard reader.
Step 3 - Connect Machine Start Harness
C-0126-MLV | C-5359 |
---|---|
Machine Start Harness (SA) | Machine Start Harness (SA) |
- Connect the C-0126-MLV Machine Start Harness to the Machine Control Assembly RS-232 port.
- Connect the C-5359 Machine Start Harness to the Machine Control Assembly Input 1 port.
Step 4 - Connect and Mount FasCard Reader
C-0126-MLV | C-5359 | C-5500 |
---|---|---|
Machine Start Harness (SA) | Machine Start Harness (SA) | Power Extension Harness |
- Feed remaining harness ends through mounting hole as described in F1 Reader Mounting Guide.
- Connect the free end of the C-0126-MLV Machine Start Harness to port 1 (Serial Connection Port) as shown in the image above.
- Connect the free end of the C-5359 Machine Start Harness to port 2 (Pulse Connection Port) as shown in the image above.
- Connect the free end of the C-5500 Power Extension Harness to port 4 (C-5500 Power Harness Connection Port) as shown in the image above.
- Connect FasCard reader to C-0934 Mounting Bracket using the C-0141 screws.
- Program the card reader address as described here: How to Program Address on a FasCard Reader.