Installing the Ingenico iUC285 EMV Credit Card Bezel on a v2 Cabinet
Purpose |
---|
The purpose of this document is to guide the New LaundryCard User through the EMV Ingenico Credit Card Reader installation. These instructions are applicable to V2 X-Changer Cabinets with pre-drilled holes for the Credit Card Reader. Estimated Installation Time: 30 minutes per cabinet |
Required Parts
Prerequisites
Existing LaundryCard System
New acrylic panel installed and mounting holes drilled: Installing The Replacement Acrylic on an Existing Version 2 X-Changer Cabinet Upgrading to EMV
New LaundryCard System
The X-Changer should have arrived with the new acrylic installed and the pre-drilled holes for the Credit Card Bezel.
Installation
Insert the C-1008 Ingenico bezel into the acrylic opening and secure with four C-1011 screws.
Plug the C-1330 USB cable into the USB port on the rear of the Ingenico device.
Route the USB cable to the rear of the Dell computer by weaving around the door harness.
Connect the USB cable to an available USB port on the rear of the Dell computer.
Repeat for all X-Changers.
The Ingenico device will not work properly until the software is installed and merchant account is set up. Verify the merchant account is setup with Datacap NETePay, and then contact CCI Support at (630) 930-5115 to install the software.