Installing The MEI Credit Card Combo Bezel
This installation guide is meant to provide step-by-step instructions on how to install the MEI Credit Card Combo Bezel for LaundryCard X-Changers.
Required Parts
| Part ID | Description |
|---|---|
| C-1004B | |
| C-1004B-PWR | |
| C-1004B-Y |
Required Tools
Phillips head screwdriver | |
Socket wrench Socket: 11/32" |
Step-by-Step Guide
The installer will need to install the MEI credit card bezel to the front of the X-Changers. You will need an 11/32” deep well socket and a #2 Philips head screwdriver.
Remove the cash box from the Bill Acceptor located on the inside of the front X-Changer door.
Unplug the power (smaller) and data (larger) cables from the right side of the Bill Acceptor.
Remove the four 11/32” nuts holding the bill acceptor on the door and set them aside. Take care not to let it drop to the floor.
Pull the Bill Acceptor out of the X-Changer door towards the inside and place it on a flat surface.
Place the Credit Card Bezel on the front of the Bill Acceptor and attach it with the provided screws.
Place the Bill Acceptor with the attached Credit Card Bezel back into the door of the X-Changer.
Put the green ground cable onto the screw stud and replace the four 11/32 kep nuts and hand tighten.
Thread Bezel Serial Cable around the door harness to the back of the computer.
Install the Bezel "Y" Cable to the open port on the back of the computer.
Usually, the open SUNIX expansion slot serial port is near the power cable.
Plug the flat serial connection from the Credit Card Bezel into the flat serial connection of Bezel "Y" Cable until it clicks.
Plug the round barrel connector of the Bezel Power Cable into the rount barrel connector of the Bezel "Y" Cable.
Plug the power cable of the Bezel Power Cable into an available outlet on the bottom Tripp-Lite Surge Protector.
Do not plug into the Tripp-Lite Battery Backup at the bottom.